1. |
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
|
2. |
Remove the front wheel and tire (A) from front hub .
|
3. |
Remove the brake caliper mounting bolts (A), and then place the
brake caliper assembly (B) with wire.
|
4. |
Loosen the coking nut (A) and screw (B) then remove the front
brake disc (C).
|
5. |
Remove the tie rod end ball joint (A) from the knuckle.
|
6. |
Loosen the mount bolt and then remove the wheel speed sensor (A)
from knuckle.
|
7. |
Remove the lower arm (A) from the knuckle.
|
8. |
Disconnect the driveshaft (A) from the front hub assembly.
|
9. |
Loosen the strut mounting bolts and then remove the knuckle assembly
(A).
|
PTC Heater Inspection
Operating Logic Test (Manual only)
Inspect the PTC operation with the confirmation logic below :
1.
Entering
(1)
Set the Floor mode ...
Rear Hub - Carrier Components
1. Rear torsion beam axle assembly
2. Rear dust cover
3. Rear wheel hub assembly
4. Rear brake disc
...
Front Door Module Replacement
1.
Remove the front door window glass.
(Refer to Front Door - "Front Door Window Glass")
2.
Disconnect the front door main con ...