Kia Optima Manuals

Kia Forte: Front Hub / Knuckle Disassembly - Front Axle Assembly - Driveshaft and axle - Kia Forte TD 2014-2018 Service ManualKia Forte: Front Hub / Knuckle Disassembly

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Driveshaft and axle / Front Axle Assembly / Front Hub / Knuckle Disassembly

1.
Remove the snap ring (A).
2.
Remove the hub assembly from the knuckle assembly.
(1)
Install the front knuckle assembly (A) on press.
(2)
Lay a suitable adapter (B) upon the hub assembly shaft.

3.
Remove the hub bearing inner race from the hub assembly.
(1)
Install a suitable tool (A) for removing the hub bearing inner race on the hub assembly.
(2)
Lay the hub assembly and tool (A) upon a suitable adapter (B).
(3)
Lay a suitable adapter (C) upon the hub assembly shaft.
(4)
Remove the hub bearing inner race (D) from the hub assembly by using press.

4.
Remove the hub bearing outer race from the knuckle assembly.
(1)
Lay the hub assembly (A) upon a suitable adapter (B).
(2)
Lay a suitable adapter (C) upon the hub bearing outer race.
(3)
Remove the hub bearing outer race from the knuckle assembly by using press.

5.
Replace hub bearing with a new one.
Front Hub / Knuckle Replacement
1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A ...

Front Hub / Knuckle Reassembly
1. Install the hub bearing to the knuckle assembly. (1) Lay the knuckle assembly (A) on press. (2) ...

See also:

Components Operations
ECM (Engine Control Module) 1. The ECM(PCM) (A) carries out a check of the ignition key using a special encryption algorithm, which is programmed into the transponder ...

Engine Control Module (ECM) Installation
   When replacing the ECM, the vehicle equipped with the immobilizer must be performed procedure as below. ...

Drive Belt Inspection
1. Check belt for maintenance and abnormal wear of V-ribbed part. Replace if necessary.    ...

Categories


Copyright © www.kifomanual.com 2014-2024