|
1. |
Remove the Front Driveshaft.
(Refer to Driveshaft Assembly - “Front Driveshaft”)
|
2. |
Remove the circlip (B) from the driveshaft spline (A).
|
3. |
Remove both boot bands from the TJ case.
|
4. |
Remove the TJ case (A).
|
5. |
Remove the snap ring (A) from the shaft.
|
6. |
Remove the spider assembly (B) from the driveshaft (A) using the
special tool (09495-33000).
|
7. |
Clean the spider assembly.
|
8. |
Remove the TJ boot (A).
|
Front Stabilizer Bar Inspection
1.
Check the bushing for wear and deterioration.
2.
Check the front stabilizer bar for deformation.
...
Spark Plug Inspection
[On vehicle inspection]
1.
Accelerate the engine to about 3,000 rpm 3 times or more.
2.
Remove the spark plug.
...
Crankshaft Components
1. Crankshaft upper bearing
2. Crankshaft thrust bearing
3. Crankshaft
4. Crankshaft lower bearing
5. Crankshaft position sensor (CKPS) wheel
6. Lower crankcase
7. Gas ...