Kia Forte: BJ Boot Components
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Driveshaft and axle / Driveshaft Assembly / BJ Boot Components
| 1. BJ assembly 2. Circlip 3. BJ boot band 4. BJ boot |
5. Dynamic damper band 6. Dynamic damper 7. Shaft 8. TJ boot band |
9. TJ boot 10. Spider assembly 11. Snap ring 12. TJ case |
13. Circlip |
Dynamic Damper Installation
1.
Apply soap powder on the shaft to prevent being damaged between
the shaft spline and the dynamic damper.
2.
Install the dynamic damper.
...
BJ Boot Replacement
1.
Remove the front driveshaft.
(Refer to Driveshaft Assembly - “Front Driveshaft”)
2.
Remove the TJ joint assembly.
(Refer to ...
See also:
Blower Resistor Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Disconnect the blower resistor connector (A) and then remove the
blower resistor (B) af ...
Transaxle Control Module (TCM) Replacement
1.
Turn ignition switch OFF.
2.
Disconnect the negative (-) battery cable.
3.
Disconnect the TCM connector (A ...
Control Cable Components
1. Shift lever knob
2. Shift lever assembly
3. Shift cable assembly
4. Select cable assembly
5. Retainer
...
Copyright © www.kifomanual.com 2014-2024