When using a commercially available computerized wheel alignment
equipment to inspect the rear wheel alignment, always position the vehicle
on a level surface.
Prior to inspection, make sure that the rear suspension system
is in normal operating condition and that the tires are inflated to
the specified pressure.
|
B - A > 0: Toe in (+)
B - A < 0: Toe out (-)
|
1. |
Loosen the nut holding the assist arm cam bolt.
|
2. |
Adjust rear toe by turning the rear assist arm cam bolt clockwise
or counter clockwise. Toe adjustment should be made by turning the right
and left cam bolt by the same amount.
|
3. |
When completing the toe adjustment, tighten the nut to specified
torque.
|
Camber : -1.5° ± 0.5°
|
Front Strut Assembly Inspection
1.
Check the strut bearing for wear and damage.
2.
Check the spring upper and lower seat for damage and deterioration.
3.
...
Components Location
1. Battery sensor
2. Brake Booster Vacuum Pressure Sensor (BBVPS)
3. AGM battery
4. DC/ DC Converter
5. ISG OFF Switch
6. Alternator
7. Starter
8. Brake switch
...
Heated Oxygen Sensor (HO2S) Circuit Diagram
(M/T)
(A/T)
...