When the receiver first arrives for replacement:
|
It is important to make sure that the correct receiver is used
to replace the faulty part i.e. it must be Low Line and not High Line
in order to have the correct inflation warning thresholds set.
|
1. |
Disconnect the negative (-) battery cable.
|
2. |
Remove the center fascia panel.
(Refer to Crash Pad - "Center Fascia Panel")
|
3. |
Remove the cluster fascia panel.
(Refer to Crash Pad - "Cluster Fascia Panel")
|
4. |
After loosening the mounting screws, then remove the drive airvent
duct assembly (A).
|
5. |
After loosening the mounting screws, then remove the clock fascia
panel (A).
|
6. |
Disconnect the clock switch connector (A).
|
7. |
After loosening the mounting screws, then remove the center airvent
duct assembly [RH] (A).
|
8. |
Remove the in-car hose (A).
|
9. |
Disconnect the in-car sensor connector (B).
|
10. |
After loosening the mounting screws, then remove the crash pad
upper panel (A).
|
11. |
Disconnect the connector (A).
|
12. |
Remove the bracket and receiver (B) as loosen the nut (C-1ea).
|
13. |
Install in the reverse order of removal.
|
14. |
Re-connect battery and turn Ignition on.
|
15. |
After replacing the receiver, learn by using self-diagnosis device(GDS).
|
Removal
1.
Set the front tires straight-ahead before removing the steering
wheel.
...
Tightening Torques
Items
N.m
kgf.m
lb-ft
Oil drain plug
58.9 ~ 78.5
6.0 ~ 8.0
43.4 ~ 57.8
Oil filler plug
58.9 ~ 78.5
6.0 ~ 8.0
...
Oil Pump Removal and Installation
1.
Remove the timing chain cover.
(Refer to Timing System – “Timing Chain Cover”)
2.
Remove the oil pump cover (A).
...