Kia Forte: Removal

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Restraint / SRSCM / Front Impact Sensor (FIS) / Removal

•	Removal of the airbag must be performed according to the precautions/ procedures described previously.

•	Before disconnecting the front impact sensor connector, disconnect the front airbag connector(s).

•	Do not turn the ignition switch ON and do not connect the battery cable while replacing the front impact sensor.

1.	Disconnect the battery negative cable, and wait for at least three minutes before beginning work.

2.	Left side - Remove the head lamp assembly. (Refer to Body electrical - "Head Lamps") Right side - Remove the washer reservoir. (Refer to Body electrical - "Front washer motor")

3.	Disconnect the front impact sensor connector (A).

4.	Remove the front impact sensor after loosening the mounting nut (B).

Components

...

Installation

• Do not turn the ignition switch ON and do not contact the battery cable while replacin ...

See also:

BJ Boot Replacement
1. Remove the front driveshaft. (Refer to Driveshaft Assembly - “Front Driveshaft”) 2. Remove the TJ joint assembly. (Refer to ...

Front Seat Frame Assembly Replacement
• Put on gloves to protect your hands. &nb ...

Installation
1. Remove ignition key from the vehicle. 2. Disconnect the negative (-) cable from battery and wait for at least thirty seconds. ...

Categories

Copyright © www.kifomanual.com 2014-2024