Be sure to install the harness wires not to be pinched or interfered
with other parts.
|
|
1. |
Remove the ignition key from the vehicle.
|
2. |
Disconnect the battery negative cable and wait for at least thirty
seconds.
|
3. |
Install the new seat back assembly.
|
4. |
Install the front seat assembly.
(Refer to Body - "Front seat assembly")
|
5. |
Recline and slide the front seat forward fully, make sure the
harness wires are not pinched of interfering with other parts.
|
6. |
Reconnect the battery negative cable.
|
7. |
After installing the side airbag (SAB), confirm proper system
operation:
|
Heater Unit Component Location
...
Circuit Diagram
...
Crankshaft Position Sensor (CKPS) Inspection
1.
Check signal waveform of CKPS and CMPS using a scan tool.
Specification:
Refer to “Waveform”
...