1. |
Disconnect the battery negative cable, and wait for at least thirty
seconds before beginning work.
|
2. |
Remove the seat belt after pushing the lock pin (A).
|
3. |
Remove the door scuff trim.
(Refer to Body - "Door scuff trim")
|
4. |
Remove the center pillar trim.
(Refer to Body - "Center pillar trim")
|
5. |
Remove the upper anchor bolt.
|
6. |
Loosen the seat belt pretensioner mounting bolts (B) and remove
the seat belt pretensioner.
|
7. |
Disconnect the seat belt pretensioner connector (A).
|
PTC Heater Inspection
Operating Logic Test (Manual only)
Inspect the PTC operation with the confirmation logic below :
1.
Entering
(1)
Set the Floor mode ...
DC/DC Converter Description
Due to the considerably more frequent occurrence of starting operations,
the electrical load that occurs often leads to voltage dips in the vehicle network.
In order to stabilize the power s ...
Output Speed Sensor Specifications
▷ Type: Hall effect sensor
Operation condition [°C(°F)]
((-)40 ~ 150)) -40 ~ 302
Air gap(mm)in.
(1.1 ~ 1.55)
0.043 ~ 0.061
Output voltage
...