1. |
Remove the ignition key from the vehicle.
|
2. |
Disconnect the battery negative cable and wait for at least thirty
seconds.
|
3. |
Install the seat belt pretensioner with bolts (B).
|
4. |
Connect the seat belt pretensioner connector (A).
|
5. |
Install the upper anchor bolt.
|
6. |
Install the center pillar trim.
(Refer to Body - "Center pillar trim")
|
7. |
Install the door scuff trim.
(Refer to Body - "Door scuff trim")
|
8. |
Insert the seat belt to the Emergency fastening device.
|
9. |
Reconnect the battery negative cable.
|
10. |
After installing the seat belt pretensioner, confirm proper system
operation:
|
In-car Sensor (DATC only) Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the center fascia panel.
(Refer to Body - "Center Fascia Panel")
...
Power Window Switch Circuit Diagram
Driver Power Window Switch
[Driver/Passenger Safety]
[Driver Auto Down]
Passenger Power Window Switch
Rear Power Window Switch
...
Control Cable Removal
1.
Remove the floor console assembly.
(Refer to Body - " Floor Console")
2.
Remove the select cable (B) by removing the snap ...