Kia Forte: Removal
| 1. |
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
|
| 2. |
Remove the battery (A) and ECM (B).
|
| 3. |
Remove the master cylinder.
(Refer to Master Cylinder)
|
| 4. |
Remove the snap pin (A) and clevis pin (B).
|
| 5. |
Remove the mounting nuts (A).
|
| 6. |
Disconnect the vacuum hose (A) from the brake booster.
|
| 7. |
Remove the brake booster (B).
|
Brake Booster Operating Test
For simple checking of the brake booster operation, carry out the following
tests.
1.
Run the engine for one or two minutes, and then stop it. If the
pedal depresses ...
Inspection
1.
Inspect the check valve in the vacuum hose.
Do not remove the check va ...
See also:
Auto Light Sensor Installation
1.
Reconnect the auto light connector.
2.
Install the auto light sensor.
...
Door Scuff Trim Replacement
(4Door, 5Door)
•
Put on gloves to protect your hands.
...
Room lamp
To turn the room lamp ON or OFF, push the switch.
If your vehicle is not equipped with a map lamp, the room lamp will also turn
on or off as follows.
The room lamp comes on when a door is opene ...
Copyright © www.kifomanual.com 2014-2024