Kia Forte: Removal
| 1. |
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
|
| 2. |
Disconnect the vacuum pump connector (A).
|
| 3. |
Remove the air duct and air cleaner assembly.
(Refer to Engine Mechanical System - "Air Cleaner")
|
| 4. |
Disconnect the vacuum hose clip (A) and wiring harness clip (B)
from the vacuum pump bracket.
|
| 5. |
Remove the under covers (A).
|
| 6. |
Remove the intercooler inlet hose (A).
|
| 7. |
Disconnect the vacuum hose (A).
|
| 8. |
Loosen the vacuum pump bracket bolts (A) and then remove vacuum
pump and bracket.
|
| 9. |
Remove the bolts and then remove the vacuum pump (A) and lead
wire assembly (B) from the bracket (C).
|
Vacuum Pump
Components
1. Vacuum pump
2. Bracket
3. Lead wire assembly
...
Inspection
1.
Check the brake warning lamp in the IGN ON position.
Brake warnin ...
See also:
Removal
1.
Remove the air cleaner assembly.
(Refer to Engine Mechanical System - "Air Cleaner")
2.
Remove the battery and battery tray ...
Input Speed Sensor Signal Waveform
Fig 1) Input/Output speed sensor at low speed
Fig 2) Input/Output speed sensor at high speed ...
Installation
1.
Install in the reverse order of removal.
2.
After be equipped, perform bleeding air procedure in clutch release
cylinder after pouring t ...
Copyright © www.kifomanual.com 2014-2024