1. |
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
|
2. |
Remove the front wheel and tire (A) from front hub .
|
3. |
Remove the driveshaft coking nut (A).
|
4. |
Remove the tie rod end ball joint (A) from the knuckle.
|
5. |
Remove the lower arm (A) from the knuckle.
|
6. |
Using a plastic hammer, disconnect driveshaft (A) from the axle
hub (B).
|
7. |
Loosen the inner shaft mounting bolt (A). (T-GDI Engine only)
|
8. |
Insert a pry bar (A) between the transaxle case and joint case,
and separate the drive shaft (B) from the transaxle case.
|
9. |
Install in the reverse order of removal.
|
10. |
Check the front alignment.
(Refer to Suspension System - "Front Alignment")
|
Installation
Clutch cover and disc should be replaced as a set.
1.
Apply grease on a disc spline ...
Removal
The side airbag cannot be disassembled from the seat back assembly,
so replace assembly when replacing the side airbag.
...
Blade inspection
Commercial hot waxes applied by automatic car washes have been known to make
the windshield difficult to clean.
Contamination of either the windshield or the wiper blades with foreign matter
ca ...