1. |
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
|
2. |
Remove the front wheel and tire (A) from front hub .
|
3. |
Remove the brake caliper mounting bolts (A), and then place the
brake caliper assembly (B) with wire.
|
4. |
Loosen the coking nut (A) and screw (B) then remove the front
brake disc (C).
|
5. |
Remove the tie rod end ball joint (A) from the knuckle.
|
6. |
Loosen the mount bolt and then remove the wheel speed sensor (A)
from knuckle.
|
7. |
Remove the lower arm (A) from the knuckle.
|
8. |
Disconnect the driveshaft (A) from the front hub assembly.
|
9. |
Loosen the strut mounting bolts and then remove the knuckle assembly
(A).
|
Component
1. Concentric slave cylinder assembly
2. Manual transaxle
...
Rear Coil Spring Inspection
1.
Check the coil spring for crack and deformation.
2.
Check the coil spring pad for damage and deformation.
...
Fuses
A vehicle's electrical system is protected from electrical overload damage by
fuses.
This vehicle has 2 fuse panels, one located in the driver's side panel bolster,
others in the engine ...