Kia Forte: Front Seat Cushion Track Replacement
| •
|
When replacing the WCS, be sure to check the parts unit.
|
| -
|
Parts unit of WCS : seat track assembly
|
|
| •
|
Put on gloves to protect your hands.
|
|
| •
|
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protective tape around the related
parts, to prevent damage.
|
| •
|
Use a plastic panel removal tool to remove interior trim
pieces to protect from marring the surface.
|
| •
|
Take care not to bend or scratch the trim and panels.
|
|
|
1. |
Remove the front seat shield inner cover.
(Refer to Front Seat - "Front Seat Shield Inner Cover")
|
|
2. |
Remove the front seat shield outer cover.
(Refer to Front Seat - "Front Seat Shield Outer Cover")
|
|
3. |
Loosen the front seat cushion track front mounting bolt (A).
Tightening torque :
44.1 ~ 53.9 N.m (4.5 ~ 5.5 kgf.m, 32.5 ~ 39.8 lb-ft)
|
|
|
4. |
Pull up the front seat cushion track.
|
|
5. |
Disconnect the rear height motor connector (A).
|
|
6. |
Loosen the front seat cushion track rear mounting bolt (A).
Tightening torque :
44.1 ~ 53.9 N.m (4.5 ~ 5.5 kgf.m, 32.5 ~ 39.8 lb-ft)
|
|
|
7. |
After loosening the mounting bolts and nuts, then remove the front
seat cushion track (A).
Tightening torque :
44.1 ~ 53.9 N.m (4.5 ~ 5.5 kgf.m, 32.5 ~ 39.8 lb-ft)
|
[LH]
[RH]
|
|
8. |
Install in the reverse order of removal.
|
• |
Make sure the connector is plugged in properly.
|
|
• |
Replace any damaged clips.
|
|
|
1. Front seat cushion track
...
See also:
Limp Home Function
1.
Limp Home By Tester
If the ECM detects the fault of the Immobilizer or transponder,
the ECM will allow limp home function of the immobilizer. Limp home
is o ...
Engine Room Under Cover Components
1. Under cover front pannel.
2. Engine room LH under cover
3. Engine room RH under cover
...
Specification
Smart Key Unit
Items
Specification
Rated voltage
DC 12V
Operating voltage
DC 9 ~ 16V
Operating temperature
-30°C ~ 75°C (- ...
Front Seat Cushion Track Component Location
Rear Seat