1. |
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
|
2. |
Remove the front wheel and tire (A) from front hub.
|
3. |
Remove the wheel speed sensor (A) bracket from the front strut
assembly by loosening the mounting bolts (B).
|
4. |
Disconnect the stabilizer link (A) from the front strut assembly
after loosening the nut.
|
5. |
Remove the cowl top cover (A).
(Refer to Body - "Cowl Top Cover")
|
6. |
Remove the front strut assembly and then loosen the strut mounting
nuts (A).
|
7. |
Disconnect the front strut assembly (A) from the knuckle by loosening
the bolt & nut.
|
8. |
Installation is the reverse of removal.
|
9. |
Check the front alignment.
(Refer to Front Suspension System - "Front Alignment")
|
Certification label
The certification label is located on the driver's door sill at the center pillar.
This label shows the maximum allowable weight of the fully loaded vehicle. This
is called the GVWR (Gross V ...
Filler-Neck Assembly Installation
1.
Install in the reverse order of removal.
Filler-neck assembly bracket
installation bolt :
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ...
Thermostat Removal and Installation
Disassembly of the thermostat would have an adverse effect, causing
a lowering of cooling efficiency. Do not remove the ...