1. |
With the washer motor connected to the reservoir tank, fill the
reservoir tank with water.
|
2. |
Connect positive (+) battery cables to terminal 2 and negative
(-) battery cables to terminal 1 respectively.
|
3. |
Check that the motor operates normally and the washer motor runs
and water sprays from the front nozzles.
|
4. |
If they are abnormal, replace the washer motor.
|
Brake Switch Inspection
1.
Connect a circuit tester to the connector of stop lamp switch,
and check whether or not there is continuity when the plunger of the
stop lamp switch is pushed in an ...
Power Door Lock Actuators Inspection
Front Door Lock Module Inspection
1.
Remove the front door trim.
(Refer to Body - "Front Door Trim")
2.
Remove the front d ...
Operating door locks from outside the vehicle
Turn the key toward the rear of the vehicle to unlock and toward the front
of the vehicle to lock.
If you lock/unlock the door with a key, all vehicle doors will lock/unlock
automatically ...