Kia Forte: Front Washer Motor Removal
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Body Electrical System / Windshield Wiper/Washer / Front Washer Motor Removal
|
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the front bumper cover.
(Refer to Body - "Front Bumper Cover")
|
| 3. |
Remove the washer hose and disconnect the washer motor connector
(A).
|
| 4. |
Remove the washer reservoir after loosening bolts and screw.
|
Front Washer Motor Inspection
1.
With the washer motor connected to the reservoir tank, fill the
reservoir tank with water.
...
Front Washer Motor Installation
1.
Install the washer reservoir.
Before installing the pump motor, check ...
See also:
Description
Idle Stop & Go (ISG) function automatically switches off the engine when
the car is at a standstill if the and starts it again as soon as the brake pedal
is released. This not only reduce ...
Removal
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three
minutes before beginning ...
Compressor Installation
1.
Make sure the compressor mounting bolt with the correct length
is screwed in. Tighten the mounting bolts (A) with the specified tightening
order.
...
Copyright © www.kifomanual.com 2014-2024