1. |
Turn ignition switch OFF and disconnect the negative (-)battery
cable.
|
2. |
Remove the fuel pump assembly.
|
3. |
Check motor operation by fuel pump connector (A) connecting power(No.2)
and ground(No.4)
|
1. |
Turn ignition switch OFF and disconnect the negative (-)battery
cable.
|
2. |
Remove the fuel pump assembly.
|
3. |
Using an ohmmeter, measure the resistance between terminals 1
and 3 of sender connector (A) at each float level.
|
4. |
Also check that the resistance changes smoothly when the float
is moved from "E" to "F".
|
Mode Control Actuator Description
The mode control actuator is located at the heater unit.
It adjusts the position of the mode door by operating the mode control
actuator based on the signal of the A/C control unit. Pressing ...
Oil Pump Unit (OPU) Installation
1.
Install in the reverse of removal.
...
Multimedia Jack Installation
1.
Install the multimedia jack.
2.
Connect the multimedia jack connector.
3.
Install the floor console assembly ...