1. |
Remove the fuel pump (Refer to “Fuel Pump” in this group).
|
2. |
Disconnect the electric pump wiring connector (A) and the fuel
sender connector (B).
|
3. |
Remove the head assembly (A) after releasing the cushion fixing
clip (B).
|
4. |
Disconnect the fuel tube quick-connectors (C).
|
5. |
Remove the fuel sender (A) in the direction of an arrow.
|
6. |
Disconnect the fuel tube connector (A).
|
7. |
Remove the cut valve (A) after releasing hooks (B).
|
8. |
Remove the reservior-cup (B) after releasing the fixing hooks
(A).
|
9. |
Release the fixing hooks, and then remove the pre-filter (A).
|
10. |
Remove the electric motor pump motor (B) from the fuel filter
(C) by pulling it in down direction.
|
Trunk Lid Latch Component Location
(4Door)
1. Trunk lid latch assembly
(2Door)
1. Trunk lid latch assembly
...
Body Panel Gaps
...
Variable Charge Motion Actuator (VCMA) Description
The Variable Charge Motion Actuator (VCMA) is installed on the inlet of
the intake manifold.
It consists of a DC motor which actuates the VCM valve and a position
sensor which detects th ...