1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
2. |
Remove the rear seat.
(Refer to Body - “Rear Seat Assembly”)
|
3. |
Remove the fuel pump service cover (A).
|
4. |
Disconnect the fuel tank pressure sensor connector (A).
|
5. |
Remove the fuel tank pressure sensor (B) after releasing the hooks
vertically.
|
Front Stabilizer Bar Inspection
1.
Check the bushing for wear and deterioration.
2.
Check the front stabilizer bar for deformation.
...
Normal maintenance schedule
The following maintenance services must be performed to ensure good emission
control and performance.
Keep receipts for all vehicle emission services to protect your warranty. Where
both mileage an ...
Heated Oxygen Sensor (HO2S) Installation
•
Install the component with the specified torques.
•
...