1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the heater and blower assembly.
(Refer to Heater -"Heater Unit")
|
3. |
Remove the heater core cover (A) after loosening the mounting
screws.
|
4. |
Pull out the heater core (A) from the heater unit.
|
5. |
Install in the reverse order of removal.
|
Battery Sensor Removal
1.
Disconnect the battery negative (-) cable.
2.
Disconnect the battery sensor connector (A).
3.
Remove the bat ...
Fuel Tank Installation
1.
Install in the reverse order of removal.
Fuel tank band installation
nut:
39.2 ~ 54.0 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)
...
Inspection
Lighting Switch Inspection
With the multifunction switch in each position, make sure that continuity
exists between the terminals below. If continuity is not as specified, replace
the mul ...