Kia Forte: Hub nut tightening sequence

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Suspension System / maincat / Hub nut tightening sequence

Tighten the hub nuts as follows.

Tightening torque:

88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)

When using an impact gun, final tightening torque should be checked using a torque wrench.

Run out inspection

1.	Jack up the vehicle.

2.

Measure the wheel Run-out by using a dial indicator as illustration below.

Run-out	Aluminum	Steel
Radial mm(in.)	Below 0.3(0.0118)	Below 1.4(0.0551)
Lateral mm(in.)	Below 0.3(0.0118)	Below 0.9(0.0354)

3.	If measured value exceeds the standard value, replace the wheel.

maincat

...

Tire Pressure Monitoring System

...

See also:

Rear Wheel House Trim Replacement
(4Door) • Put on gloves to protect your hands. ...

Power Door Mirror Actuator Inspection
1. Disconnect the negative(-) battery terminal. 2. Remove the front door quadrant inner cover (A). 3. D ...

Fuel Pump Motor Removal
1. Remove the fuel pump (Refer to “Fuel Pump” in this group). 2. Disconnect the electric pump wiring connector (A) and the fuel sender conn ...

Categories

Copyright © www.kifomanual.com 2014-2024