1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the center fascia panel.
(Refer to Body - "Center Fascia Panel")
|
3. |
Remove the cluster fascia panel.
(Refer to Body - "Cluster Fascia Panel")
|
4. |
After loosening the mounting screws, remove the drive airvent
duct assembly (A).
|
5. |
After loosening the mounting screws, remove the clock fascia panel
(A).
|
6. |
Disconnect the clock switch connector (A).
|
7. |
After loosening the mounting screws, then remove the center airvent
duct assembly [RH] (A).
|
8. |
Remove the in-car hose (A).
|
9. |
Disconnect the in-car sensor connector (B).
|
10. |
Loosen the mounting screws and then remove the in-car sensor (A)
located in the back side of the center airvent duct assembly [RH].
|
11. |
Install in the reverse order of removal.
|
Component Location
1. Auto light sensor
2. Head lamps
3. Lighting switch (Auto)
4. Tail lamps
5. Body control module (BCM)
...
Emergency Fastening Device (EFD)
Front emergency fastening device operates as well as belt pretensioner
at the same time If it gets into its deploy condition after a collision. It
is located at near anchor on front seat and ...
Front Bumper Cover Component Location
(4Door)
1. Front bumper cover
(5Door, 2Door)
1. Front bumper cover
...