|
1. |
Disconnect the Inhibitor swtich connector.
|
2. |
Ignition KEY "ON"" & Engine "OFF".
|
3. |
Measure voltge between supplied power and ground at inhibitor
circuit.
|
1. |
Connect the Inhibitor switch connector.
|
2. |
Ignition KEY "ON" & Engine "OFF".
|
3. |
Measure voltages between each terminal and chassis ground during
shift lever changed "P, R, N, D".
Signal Code Table
|
Dynamic Damper Installation
1.
Apply soap powder on the shaft to prevent being damaged between
the shaft spline and the dynamic damper.
2.
Install the dynamic damper.
...
Photo Sensor Inspection
1.
Turn the ignition switch ON.
2.
Connect the GDS.
3.
Emit intensive light toward the photo sensor using a lam ...
Installation
1.
Install the multifunction switch.
2.
Install the clock spring.
3.
Install the steering column upper and lowe ...