Kia Optima Manuals

Kia Forte: Inspection - Brake Pedal - Brake System - Brake System - Kia Forte TD 2014-2018 Service ManualKia Forte: Inspection

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Brake System / Brake System / Brake Pedal / Inspection

1.
Check the bushing for wear.
2.
Check the brake pedal for bending or twisting.
3.
Check the brake pedal return spring for damage.
4.
Check the stop lamp switch.
(1)
Connect a circuit tester to the connector of stop lamp switch, and check whether or not there is continuity when the plunger of the stop lamp switch is pushed in and when it is released.
(2)
The stop lamp switch is in good condition if there is no continuity when plunger(A) is pushed.
Removal
1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the crash pad lower panel. (Refer to Body - & ...

Installation
1. Pre-tighten the bracket fixing bolt (A) in dash panel. 2. Install the brake booster and brake pedal member fixing nuts (A) secur ...

See also:

Components Location
1. Engine Control Module (ECM) 2. Manifold Absolute Pressure Sensor (MAPS) 3. Intake Air Temperature Sensor (IATS) 4. Engine Coolant Temperature Sensor (ECTS) 5. Throttle Positi ...

Front Cross Member
* These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ] ...

Shift Lever Inspection
1. Check operating of lever of T/M side when operating shift lever after assembly. 2. When shift lever to "R" position, check th ...

Categories


Copyright © www.kifomanual.com 2014-2024