Rear Brake Disc Thickness Check |
1. |
Check the brake pads for wear and fade.
|
2. |
Check the brake disc for damage and cracks.
|
3. |
Remove all rust and contamination from the surface, and measure
the disc thickness at 8 points, at least, of same distance (5mm) from
the brake disc outer circle.
|
4. |
If wear exceeds the limit, replace the discs and pad assembly
left and right of the vehicle.
|
Rear Brake Pad Check |
1. |
Check the pad wear. Measure the pad thickness and replace it,
if it is less than the specified value.
|
2. |
Check the damage of pad, backing metal and contamination with
grease.
|
Rear Brake Disc Runout Check |
1. |
Place a dial gauge about 5mm (0.2 in.) from the outer circumference
of the brake disc, and measure the runout of the disc.
|
2. |
If the runout of the brake disc exceeds the limit specification,
replace the disc, and then measure the runout again.
|
3. |
If the runout exceeds the limit specification, install the brake
disc after turning it 180° and then check the runout of the brake disc
again.
|
4. |
If the runout cannot be corrected by changing the position of
the brake disc, replace the brake disc.
|
Antenna Coil Installation
1.
Install the antenna coil.
2.
Connect the antenna coil connector.
3.
Install the crash pad lower panel.
...
Fuel Tank Pressure Sensor (FTPS) Specification
Pressure [kPa (kgf/cm², in H2O)
Output Voltage (V)
-6.67 (-0.068, -26.8)
0.5
0
2.5
+6.67 (0.068, 26.8)
4.5
...
Components
1. Driver Airbag (DAB)
2. Steering Wheel
3. Clock Spring
4. Seat Belt Pretensioner (BPT)
5. Pressure Side Impact Sensor (P-SIS)
6. Side Impact Sensor (SIS)
7. Side Airbag ...