1. |
Remove the front door trim.
(Refer to Body - "Front Door Trim")
|
2. |
Remove the front door module.
(Refer to Body - "Front Door Module")
|
3. |
Disconnect the connector from the actuator.
|
4. |
Check actuator operation by connecting power and ground according
to the table. To prevent damage to the actuator, apply battery voltage
only momentarily.
|
1. |
Remove the rear door trim.
(Refer to Body - "Rear Door Trim")
|
2. |
Remove the rear door module.
(Refer to Body - "Rear Door Module")
|
3. |
Disconnect the connector from the actuator.
|
4. |
Check actuator operation by connecting power and ground according
to the table. To prevent damage to the actuator, apply battery voltage
only momentarily.
|
[2/4 Door] |
1. |
Remove the trunk lid trim.
(Refer to Body - "Trunk Lid Trim")
|
2. |
Disconnect the connector from the actuator.
[2 Door]
[4 Door]
|
3. |
Check actuator operation by connecting power and ground according
to the table. To prevent damage to the actuator, apply battery voltage
only momentarily.
|
[5 Door] |
1. |
Remove the tailgate trim.
(Refer to Body - "Tailgate Trim")
|
2. |
Disconnect the connector from the actuator.
|
3. |
Check actuator operation by connecting power and ground according
to the table. To prevent damage to the actuator, apply battery voltage
only momentarily.
|
1. |
Disconnect the connector from the hood switch (A).
|
2. |
Check for continuity between the terminals and ground according
to the table.
|
1. |
Remove the burglar horn (A) after removing a nut and disconnect
the connector (B) from the burglar horn.
|
2. |
Test the burglar horn by connecting battery power to the terminal
1 and ground the terminal 2.
|
3. |
The burglar horn should make a sound. If the burglar horn fails
to make a sound replace it.
|
Component
1. Concentric slave cylinder assembly
2. Manual transaxle
...
ECM Problem Inspection Procedure
1.
TEST ECM GROUND CIRCUIT: Measure resistance between ECM and chassis
ground using the backside of ECM harness connector as ECM side check
point. If the problem is fo ...
Hood Weatherstrip Replacement
1.
Remove the hood weatherstrip (A).
•
...