1. |
After disconnecting the vapor hose from the PCV valve, remove
the PCV valve.
|
2. |
Reconnect the PCV valve to the vapor hose.
|
3. |
Run the engine at idle, then put a finger over the open end of
the PCV valve and make sure that intake manifold vacuum can be felt.
|
4. |
If the vacuum is not felt inspect PCV operation, if operating
correctly clean or replace the vapor hose.
|
SS-A Solenoid Valve(ON/OFF) Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the Solenoid valve connector.
3.
Measure resistance between sensor ...
Smart Key Unit Component
Component (1)
Connector Pin Information
No.
Connector A (24 pins)
No.
Connector B (20 pins)
No.
Connector C (18 pins)
1
VBAT CPU
...
Auto Defogging Sensor Description
The auto defogging sensor is installed on the front windshield glass.
The auto defogging sensorr senses moisture on the windshild. The air conditioner
control module receives the signal from ...