1. |
Pre-tighten the bracket fixing bolt (A) in dash panel.
|
2. |
Install the brake booster and brake pedal member fixing nuts (A)
securely.
|
3. |
Tighten the bolt (A) securely in dash panel.
|
4. |
Install the snap pin (A) and clevis pin (B).
|
5. |
Install the stop lamp switch securely.
|
6. |
Connect the stop lamp switch connector (A).
|
7. |
Adjust the brake pedal height and free play.
|
8. |
Check the brake pedal operation after installing the brake pedal.
|
9. |
Install the shower duct (A).
|
10. |
Install the crash pad lower panel.
(Refer to Body - "Crash pad lower panel")
|
11. |
Reconnect the battery negative cable.
|
Rear Oil Seal Installation
1.
Install a new rear oil seal.
(1)
Apply engine oil on the edge of new oil seal.
(2)
...
Transaxle Oil Temperature Sensor Removal
1.
Disconnect the negative (-) battery cable.
2.
Remove the air cleaner assembly and air duct.
(Refer to Engine Mechanical System - &qu ...
Oil Pump Unit (OPU) Connector
Opu Connector Terminal Function
E56-A
E56-B
Pin No.
Description
Pin No.
Description
1
Motor power(W)
1
...