Kia Forte: Installation

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Clutch System / Ignition Lock Switch / Installation

1.	Install in the reverse order of removal.

2.

Adjust the ignition lock switch.

(1)

In state of full stroke, adjust the gab by rotating the adjust nut (A) to satisfy the standard gap range.

Standard gap range :

3 ~ 4 mm (0.1181 ~ 0.1575 in.)

(2)

Tighten the nut (B) with the specified torque.

Tightening torque:

7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.8 ~ 7.2 lb-ft)

Removal

1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the smart junction box. (Refer to Body Electri ...

Clutch Pedal

...

See also:

Hands Free Switch Installation
1. Reassemble the steering wheel remote control switch after connecting the connector. 2. Reassemble the driver airbag module. ...

Replacement
1. Remove the air cleaner assembly. (Refer to Engine Mechanical System - "Air Cleaner") 2. Remove the battery and battery tray ...

CVVT & Camshaft Inspection
Camshaft 1. Inspect the cam lobes. Using a micrometer, measure the cam lobe height. If the cam lobe height is less than specification, replace the camsh ...

Categories

Copyright © www.kifomanual.com 2014-2024