Kia Forte: Installation

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Clutch System / Clutch Release Fork and Clutch Release Bearing / Installation

1.	Install the boot (A).

2.	Install the clip to the clutch release fork.

3.

Apply to grease in location A, B and C.

Location	Quantity (g)	Remarks
A	0.3 ~ 0.5	Release bearing & Fork
B	0.5 ~ 1.0	Release Fork & Fulcrum
C	0.4 ~ 0.8	Release cylinder & Fork

4.

Apply the grease to the hole surface of the clutch release bearing all around.

Specified grease : CASMOLY L9508

Amount : 0.5 ~ 1.0 g

5.	Install the clutch release fork (B), clutch release bearing (A).

6.	Install the transaxle assembly. (Refer to Manual Transaxle System - " Manual Transaxle")

Inspection

1. Check for damage to boot. 2. Check for deformation to clutch release fork. 3. Check for deformation to clutc ...

Concentric Slave Cylinder Assembly

...

See also:

Ignition Coil Circuit Diagram
[M/T] [A/T] ...

Purge Control Solenoid Valve (PCSV) Installation
• Install the component with the specified torques. • ...

Instrument Cluster Control
Adjusting Instrument Cluster Illumination The instrument panel illumination intensity can be adjusted by pressing the control switch with the headlight switch in any position when the ignition s ...

Categories

Copyright © www.kifomanual.com 2014-2024