Kia Forte: Installation
|
1. |
Install in the reverse order of removal.
|
|
If the oil seal on the transaxle case side is damaged and fluid
is leaking, replace the oil seal with a new unit. When installing the
new oil seal, use the specialized tool (oil seal installer, 09452-26100).
|
|
After replacement or reinstallation procedure of the automatic
transaxle assembly, must perform procedures below.
| •
|
Adding automatic transaxle fluid.
(Refer to Hydraulic System - "Fluid")
|
| •
|
After replacing the automatic transaxle, clear the Diagnostic
Trouble Code(DTC) using the GDS tool. DTC cannot be cleared
by disconnecting the battery.
|
| •
|
When replacing the automatic transaxle, reset the automatic
transaxle's values by using the GDS.
|
| •
|
Perform TCM learning after replacing the transaxle to
prevent slow transaxle response, jerky acceleration and jerky
startup.
(Refer to Automatic Transaxle Control System - "Repair
procedures")
|
|
1.
Engine cover.
(Refer to Engine Mechanical System - "Engine cover")
2.
Air cleaner assembly and air duct.
(Refe ...
See also:
Identification Number
Identification Number Description
Vehicle Identification Number
1.
World Manufacturer Identifier (WMI)
- KNA : Passenger vehicle, MPV(Multipurpose Passen ...
PTC Heater Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel" ...
Instrument Cluster Inspection
1.
Check point (Warning indicator)
NO
Ref
Symbol
Color
Name
Signal Input
Signal Control
(U ...
Removal
Hydraulic System