Pressure Side Impact Sensor |
1. |
Install the new pressure side impact sensor with the screws (B)
then connect the pressure side impact sensor connector (A).
|
2. |
Install the front door trim.
(Refer to Body - "Front door trim")
|
3. |
Reconnect the battery negative cable.
|
4. |
After installing the pressure side impact sensor, confirm proper
system operation:
|
|
1. |
Install the new side impact sensor (B) with the bolt then connect
the side impact sensor connector (A).
|
2. |
Install the center pillar lower trim.
(Refer to Body - "Center pillar trim")
|
3. |
Install the door scuff trim.
(Refer to Body - "Door scuff trim")
|
4. |
Reconnect the battery negative cable.
|
5. |
After installing the Side Impact Sensor, confirm proper system
operation:
|
Adjustment
(4Door, 2Door)
1.
After loosening the trunk lid hinge (A) mounting bolt, adjust
the trunk lid by moving it up or down, or right or left.
2 ...
Auto Defogging Sensor Description
The auto defogging sensor is installed on the front windshield glass.
The auto defogging sensorr senses moisture on the windshild. The air conditioner
control module receives the signal from ...
Purge Control Solenoid Valve (PCSV) Removal
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Disconnect the purge control solenoid valve connector (A) ...