Kia Optima Manuals

Kia Forte: Installation - Seat Belt Buckle Sensor (BS) - SRSCM - Restraint - Kia Forte TD 2014-2018 Service ManualKia Forte: Installation

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Restraint / SRSCM / Seat Belt Buckle Sensor (BS) / Installation

  
Be sure to install the harness wires so they will not pinch or interfere with other parts.
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
3.
Install the seat belt buckle sensor.
Tightening torque:
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~39.8 lb-ft)
4.
Install the front seat assembly.
(Refer to Body - "Front seat")
5.
Reconnect the battery negative cable.
6.
After installing the seat belt buckle sensor, confirm proper system operation:
A.
Turn the ignition switch ON; the SRS indicator should be turned on for about six seconds and then go off.
Removal
1. Disconnect the battery negative cable, and wait for at least three minutes before beginning work. 2. Remove the front seat assembly. ...

Weight Classification System (WCS)
WCS is intended to detect the occupant’s physique in order to determine whether the passenger airbag should be suppressed or deployed. WCS classifies the front passenger side seat by measurin ...

See also:

Circuit Diagram
...

Audio Unit Removal
   • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply prote ...

Front Hub / Knuckle Disassembly
1. Remove the snap ring (A). 2. Remove the hub assembly from the knuckle assembly. (1) Install the ...

Categories


Copyright © www.kifomanual.com 2014-2024