1. |
Remove ignition key from the vehicle.
|
2. |
Disconnect the negative (-) cable from battery and wait for at
least thirty seconds.
|
3. |
Install the emergency fastening device with a bolt (B).
|
4. |
Connect the emergency fastening device connector (A).
|
5. |
Install the center pillar trim.
(Refer to Body - "Center pillar trim")
|
6. |
Install the door scuff trim.
(Refer to Body - "Door scuff trim")
|
7. |
Insert the seat belt to the emergency fastening device.
|
8. |
Reconnect the battery negative cable.
|
9. |
After installing the emergency fastening device, confirm proper
system operation:
|
Tightening Torques
Item
N.m
kgf.m
lb-ft
Ignition coil installation bolt
9.8 ~ 11.8
1.0 ~ 1.2
7.2 ~ 8.7
Spark plug installation
14.7 ~ 24. ...
DC/DC Converter Description
Due to the considerably more frequent occurrence of starting operations,
the electrical load that occurs often leads to voltage dips in the vehicle network.
In order to stabilize the power s ...
Rearview camera
The rear view camera will activate with the ignition switch on and the shift
lever in the R (Reverse) position.
Note- during initial start up, system may not display instantly due to the audio
...