Kia Optima Manuals

Kia Forte: Intake Manifold Removal and Installation - Intake And Exhaust System - Engine Mechanical System - Kia Forte TD 2014-2018 Service ManualKia Forte: Intake Manifold Removal and Installation

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Mechanical System / Intake And Exhaust System / Intake Manifold Removal and Installation

1.
Remove the engine cover.
2.
Disconnect the battery negative terminal.
3.
Disconnect the wiring connectors and harness clamps, and then remove the wiring and protectors from the intake manifold.
(1)
The intake oil control valve (OCV) connector (A)
(2)
The alternator connector (A)
(3)
The variable Intake solenoid (VIS) connector (A)
(4)
The manifold absolute pressure sensor (MAPS) & intake air temperature sensor (IATS) connector (A)
(5)
The electronic throttle control (ETC) connector (A)
(6)
The variable charge motion actuator (VCMA) connector (A)
4.
Disconnect the positive crankcase ventilation (PCV) hose (A).
5.
Disconnect the vacuum hose (A) and purge control solenoid valve (PCSV) hose (B).
6.
Unfasten the electric throttle body control (ETC) module bolts.
(Refer to Engine Control/Fuel System - "ETC (Electric throttle body control) System")
7.
Remove the intake manifold stay (A).
Tightening torque :
18.6 ~ 23.5N.m (1.9 ~ 2.4kgf.m, 13.7 ~ 17.4lb-ft)

8.
Remove the intake manifold (A) with the gasket (B).
Tightening torque :
18.6 ~ 23.5N.m (1.9 ~ 2.4kgf.m, 13.7 ~ 17.4lb-ft)

  
When installing the intake manifold, tighten the bolts and nuts with pre-torque first, and then tighten the bolts and nuts with specified torque in the sequence shown.

9.
Install in the reverse order of removal.
Intake Manifold Components
1. Intake manifold assembly 2. Intake manifold gasket 3. Electronic throttle body 4. Intake manifold stay ...

Variable Intake Solenoid(VIS) Actuator Removal and Installation
1. Disconnect the vacuum hose (A). 2. Remove the variable Intake solenoid (VIS) actuator (B) Tightening torque : ...

See also:

Injector Description
Based on information from various sensors, the ECM can calculate the fuel amount to be injected. The fuel injector is a solenoid-operated valve and the fuel injection amount is controlled by ...

Replacement
1. Disconnect the battery negative cable from the battery and then wait for at least 30 seconds. 2. Turn the steering wheel so that the fro ...

Sunroof open warning (if equipped)
If the driver removes the ignition key (smart key: turns off the engine) and opens the driver-side door when the sunroof is not fully closed, the warning chime will sound for a few seconds and a ...

Categories


Copyright © www.kifomanual.com 2014-2024