Kia Forte: ISG (Idle Stop & Go) System
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / ISG (Idle Stop & Go) System
- Description
- Operation
- Operation Condition for the ISG function
- Components Location
- Battery Sensor Description
- Brake Booster Vacuum Pressure Sensor Description
- Brake Booster Vacuum Pressure Sensor Circuit Diagram
- Brake Booster Vacuum Pressure Sensor Inspection
- Brake Booster Vacuum Pressure Sensor Removal
- Brake Booster Vacuum Pressure Sensor Installation
- AGM Battery Description
- AGM Battery Specification
- AGM Battery Adjustment
- AGM Battery Removal
- AGM Battery Installation
- AGM Battery Inspection
- AGM Battery Cleaning
- DC/DC Converter Description
- DC/DC Converter Operation Principle
- DC/DC Converter Component Location
- DC/DC Converter Circuit Diagram
- DC/DC Converter Removal
- DC/DC Converter Installation
- ISG OFF Switch Description
- ISG OFF Switch Inspection
- Alternator Description
- Alternator Specification
- Alternator On-vehicle Inpection
- Alternator Removal
- Alternator Intallation
- Starter Description
- Starter Removal
- Starter Installation
- Electric Oil Pump Description
- Electric Oil Pump Circuit Diagram
- Electric Oil Pump Removal
- Electric Oil Pump Installation
- Oil Pump Unit (OPU) Connector
- Oil Pump Unit (OPU) Circuit diagram
- Oil Pump Unit (OPU) Removal
- Oil Pump Unit (OPU) Installation
- Oil Pump Unit (OPU) Inspection
- Brake Switch Description
- Brake Switch Inspection
- Brake Switch Removal
- Brake Switch Installation
- Door Switch Description
- Door Switch Inspection
- Door Switch Removal
- Door Switch Installation
- Seat Belt Switch Description
- Seat Belt Switch Inspection
- Seat Belt Switch Removal
- Seat Belt Switch Installation
- Hood switch Description
- Hood switch Inspection
Variable Charge Motion Actuator (VCMA) Installation
•
Install the component with the specified torques.
•
...
Description
Idle Stop & Go (ISG) function automatically switches off the engine when
the car is at a standstill if the and starts it again as soon as the brake pedal
is released. This not only reduce ...
See also:
Starter Installation
1.
Install in the reverse of removal.
...
Front Strut Assembly Components
1. Strut assembly
2. Insulator
3. Strut bearing
4. Spring upper pad
5. Coil spring
6. Dust cover
7. Spring lower pad
...
Heater & A/C Control Unit (DATC) Replacement
1.
Remove the audio unit.
(Refer to Body Electrical System - "Audio Unit")
2.
After loosening the mounting screws, remove the ...
Copyright © www.kifomanual.com 2014-2024