1. |
Turn the ignition switch OFF.
|
2. |
Disconnect the mode control actuator connector.
|
3. |
Verify that the mode control actuator operates to the defog mode
when connecting 12V to the terminal 3 and grounding terminal 7.
Verify that the mode control actuator operates to the vent mode
when connecting in the reverse.
|
4. |
Connect the mode control actuator connector.
|
5. |
Turn the ignition switch ON.
|
6. |
Check the voltage between terminal 6 and 5.
Specification
It will feedback the current position of the actuator to the controls.
|
7. |
If the measured voltage is not within specification, substitute
with a known-good mode control actuator and check for proper operation.
|
8. |
Replace the mode control actuator if it is proved that there is
a problem with it.
|
Removal
The side airbag cannot be disassembled from the seat back assembly,
so replace assembly when replacing the side airbag.
...
Heater Unit Components
1. Heater Case (Left)
2. Heater Case (Right)
3. Console Separator
4. Defog Door
5. Vent Door
6. Floor Door
7. Mix Door (Manual)
8. Mix Door (DATC-Left)
9. Mix Door ( ...
AVN Head Unit Installation
1.
Connect the AVN head unit connectors and cables.
2.
Install the AVN head unit.
3.
Install the airvent ducts ...