1. |
Remove the radiator cap, wet its seal with engine coolant, and
then install it on a pressure tester.
|
2. |
Apply a pressure of 93.16 ~ 122.58 kPa (0.95 ~ 1.25 kgf/cm², 13.51
~ 17.78 psi).
|
3. |
Check for a drop in pressure.
|
4. |
If the pressure drops, replace the cap.
|
1. |
Wait until engine is cool, then carefully remove the radiator
cap and fill the radiator with engine coolant, then install it on the
pressure tester.
|
2. |
Apply a pressure tester to the radiator and apply a pressure of
93.16 ~ 122.58kpa (0.95 ~ 1.25kg/cm², 13.51 ~ 17.78psi).
|
3. |
Inspect for engine coolant leaks and a drop in pressure.
|
4. |
Remove the tester and reinstall the radiator cap.
|
35R Clutch Control Solenoid Valve(35R/C_VFS) Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the Solenoid valve connector.
3.
Measure resistance between sensor ...
Variable Charge Motion Actuator (VCMA) Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the VCMA connector.
3.
Check that the VCMA is not stuck by foreign ...
Seat belt restraint system
Seat belts are designed to bear upon the bony structure of the body, and should
be worn low across the pelvis, chest and shoulders as applicable. Wearing the lap
section of the belt across the abdom ...