1. |
Check the continuity between the terminal and the body with an
ohmmeter.
If there is no continuity, replace the oil pressure switch.
|
2. |
Check the continuity between the terminal and the body when the
fine wire is pushed. If there is continuity even when the fine wire
is pushed, replace the switch.
|
3. |
If there is no continuity when a 50 kPa (0.50 kgf/cm², 7.25 psi)
is applied through the oil hole, the switch is operaing properly.
Check for air leakage. If air leaks, the diaphragm is broken.
Replace it.
|
Adjustment
Clutch Release Cylinder Air Bleeding
Procedure
•
Use the specified fluid. Avoi ...
Rear Glass Defogger Printed Heater Inspection
Wrap tin foil around the end of the voltmeter test lead to prevent
damaging the heater line. Apply finger pressure on th ...