Kia Forte: Oil Pump Unit (OPU) Connector
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / ISG (Idle Stop & Go) System / Oil Pump Unit (OPU) Connector
| Opu Connector Terminal Function |
| E56-A |
E56-B |
||
| Pin No. |
Description |
Pin No. |
Description |
| 1 |
Motor power(W) |
1 |
CAN communication (High) |
| 2 |
Motor power(V) |
2 |
CAN communication (Low) |
| 3 |
Hall sensor(Ground) |
3 |
- |
| 4 |
Ground |
4 |
- |
| 5 |
Motor power(U) |
5 |
- |
| 6 |
Shield ground |
6 |
- |
| 7 |
Hall sensor signal input (W) |
7 |
- |
| 8 |
Hall sensor signal input (V) |
8 |
- |
| 9 |
Hall sensor signal input (U) |
9 |
Ignition ON / Start |
| 10 |
Hall sensor power |
10 |
- |
| 11 |
Battery voltage |
|
|
Electric Oil Pump Installation
1.
Install in the reverse of removal.
...
See also:
Steering Angle Sensor
The Steering Angle Sensor (SAS) is installed in MDPS (Motor Driven Power
Steering) and it sends messages to HECU through CAN communication line.
The SAS is used to determine turning directio ...
Components
1. ESC Control Module (HECU)
2. Front Wheel Speed Sensor
3. Rear Wheel Speed Sensor
4. Yaw-late & Lateral G Sensor
5. Steering Wheel Angle Sensor
6. ABS Warning Lamp
...
Evaporator Temperature Sensor Description
The evaporator temperature sensor will detect the evaporator core temperature
and interrupt compressor relay power in order to prevent evaporator freezing
by excessive cooling.
...
Copyright © www.kifomanual.com 2014-2024