Replacing an on/off solenoid valve (SS-A, SS-B) does not require
additional hydraulic pressure adjustment; however, the hydraulic pressure
will need to be adjusted after replacing the VFS solenoid valve. If
replacing the VFS solenoid valve; also replace the valve body assembly.
(Refer to "Valve Body" in this group)
|
Engine Control Module (ECM) Installation
When replacing the ECM, the vehicle equipped with the immobilizer
must be performed procedure as below.
...
Hood Latch Release Handle Replacement
1.
After loosening the mounting screw, then remove the hood latch
release handle (A).
2.
Install in the reverse order of removal.
...
Variable Charge Motion Actuator (VCMA) Components
1. Coupling
2. Shaft
3. Stabilizer O-ring
4. Stabilizer
5. O-ring
6. Insert nut
7. Stabilizer Cover
8. Valve
9. Hole cover
...