Kia Forte: Parking Assist Sensor Removal
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Body Electrical System / Parking Assist System / Parking Assist Sensor Removal
[Front Bumper]
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the front bumper cover.
(Refer to Body - "Front Bumper Cover")
|
| 3. |
Disconnect the connector (A) from the ultrasonic sensor.
|
| 4. |
Pull out the sensor (A) by opening the sensor holder (B) out.
|
[Rear Bumper]
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the rear bumper cover.
(Refer to Body - "Rear Bumper Cover")
|
| 3. |
Disconnect the connector (A) from the ultrasonic sensor.
|
| 4. |
Pull out the sensor (A) by opening the sensor holder (B) out.
|
Parking Assist Sensor Installation
1.
Install the ultrasonic sensor after connecting the connector.
2.
Install the front/rear bumper.
3.
Connect t ...
See also:
Starter Cleaning
1.
Do not immerse parts in cleaning solvent.
Immersing the yoke assembly and/or armature will damage the insulation
wipe these parts with a cloth only.
...
System Block Diagram
Component Parts And Function Outline
Component part
Function
Vehicle-speed sensor
Converts vehicle speed to pulse.
ECM
Receives signals fr ...
ECM Terminal And Input/Output signal (A/T)
ECM Terminal Function
Connector [CNG-AA]
Pin No.
Description
Connected to
1
Ignition Coil (Cylinder #2) control output
Ignition Co ...
Copyright © www.kifomanual.com 2014-2024