|
1. |
Remove the floor console to reach the adjusting nut.
|
2. |
Loosen the parking brake cable until both operating levers rest
in fully off position.
|
3. |
Bring the brake pads in their operating position by pressing the
brake pedal down several times until there is resistance.
|
4. |
Tension the parking brake cable by tightening the adjusting nut,
until the operating levers on both calipers lift from the stop, up to
a distance of (A) and (D) between operating lever (B) and stopper (C).
|
5. |
Refit the floor console.
|
6. |
Parking brake lever in the car must be in fully loosened position.
|
7. |
If the handbrake cables where changed, actuate the parking brake
a few times with maximum force to stretch the parking brake cables,
and then control adjusting as above.
|
8. |
Check the wheels of their free operation.
|
9. |
Test drive.
|
Center Pillar Trim Component Location
(4Door, 5Door)
1. Center pillar lower trim
2. Center pillar upper trim
(2Door)
1. Rear inner outer trim
2. Center pillar upper ...
Hazard Lamp Switch Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the center fascia panel.
(Refer to Body - "Center Fascia Panel")
...
Removal
1.
Disconnect the battery negative cable, and wait for at least three
minutes before beginning work.
2.
Remove the front seat assembly.
...