1. |
Install the parking brake cable (A).
|
2. |
Install the parking brake cable (B), and then install the clip
(A).
|
3. |
Install the rear tire and wheel.
|
4. |
Install the parking brake cable (B) and then cable retainer (A).
|
5. |
Apply a coating of the specified grease to each sliding parts
(A) of the ratchet plate or the ratchet pawl.
|
6. |
Install the parking brake cable adjuster, then adjust the parking
brake lever stroke by turning adjusting nut (A).
|
7. |
Release the parking brake lever fully, and check that parking
brakes do not drag when the rear wheels are turned. Readjust if necessary.
|
8. |
Make sure that the parking brakes are fully applied when the parking
brake lever is pulled up fully.
|
9. |
Reconnect the connector (A) of parking brake switch.
|
10. |
Install the floor console.
(Refer to Body - "Floor console")
|
Engine Oil Oil And Filter Replacement
•
Prolonged and repeated contact with mineral oil will result
in the removal of natural ...
Failure Diagnosis
1.
In principle, ESC and TCS controls are prohibited in case of ABS
failure.
2.
When ESC or TCS fails, only the failed system control is pr ...
Rear Oil Seal Components
1. Rear oil seal
...