The parking brake cables must not be bent or distorted. This will
lead to stiff operation and premature failure.
|
1. |
Remove the floor console assembly.
(Refer to Body - "Floor console")
|
2. |
Disconnect the connector (A) of parking brake switch.
|
3. |
Remove the parking brake cable (B) after removing the cable retainer
(A).
|
4. |
Raise the vehicle, and make sure it is securely supported.
|
5. |
Remove the rear tire and wheel.
|
6. |
Remove the parking brake cable (B), after removing the clip (A).
|
7. |
Loosen the parking brake cable bracket bolts and remove the parking
brake cable (A).
|
Water pump Components
1. Water pump pulley
2. Water pump
3. Water pump gasket
...
Smart Key Unit Installation
Smart Key Unit
1.
Install the smart key unit and RF receiver.
2.
Connect the connector and install the smart key unit.
...
Transmitter Inspection
1.
Check that the red light flickers when the door lock or unlock
button is pressed on the transmitter.
2.
Remove the battery (A) and check ...