The parking brake cables must not be bent or distorted. This will
lead to stiff operation and premature failure.
|
1. |
Remove the floor console assembly.
(Refer to Body - "Floor console")
|
2. |
Disconnect the connector (A) of parking brake switch.
|
3. |
Remove the parking brake cable (B) after removing the cable retainer
(A).
|
4. |
Remove the parking brake lever assembly (A) after removing the
bolts.
|
ESC Control Module Removal
1.
Turn the ignition switch OFF.
2.
Pull up the lock of the HECU connector (A) , then disconnect the
connector.
...
Removal
1.
Remove the mirror wiring cover (A).
2.
Disconnect the mirror connector (B).
3.
Loosen the mirror mou ...
Checking the washer fluid level
Check the fluid level in the washer fluid reservoir and add fluid if necessary.
Plain water may be used if washer fluid is not available.
However, use washer solvent with antifreeze characterist ...