1. |
Disconnect the negative(-) battery terminal.
|
2. |
Remove the front door quadrant inner cover (A).
|
3. |
Disconnect the outside rear view mirror connector (A).
|
4. |
Verify that the mirror operates properly as shown in the table.
[Actuator]
Mirror Heater
Turn Signal Lamp
Puddle Lamp
Folding Mirror
|
Wipers & Washers
A : Wiper speed control (front)
· HI – High wiper speed
· LO – Low wiper speed
· INT – Intermittent wipe
· AUTO– Automatic control wipe
· OFF – Off
· MIST – Single wipe
B : Interm ...
Tire pressure monitoring system
...
Certification label
The certification label is located on the driver's door sill at the center pillar.
This label shows the maximum allowable weight of the fully loaded vehicle. This
is called the GVWR (Gross V ...