1. |
Remove the front door trim.
(Refer to Body - "Front Door Trim")
|
2. |
Disconnect the connector from the motor.
[2 Door]
[4/5 Door]
|
3. |
Connect the motor terminals No.2 and No.3 directly to battery
voltage (12V) and check that the motor operates smoothly.
If the operation is abnormal, replace the motor.
[Safety Power Window]
|
4. |
Connect the motor terminals directly to battery voltage (12V)
and check that the motor operates smoothly. Next, reverse the polarity
and check that the motor operates smoothly in the reverse direction.
If the operation is abnormal, replace the motor.
[General Power Window]
|
1. |
Remove the rear door trim.
(Refer to Body - "Rear Door Trim")
|
2. |
Disconnect the 2P connector from the motor.
|
3. |
Connect the motor terminals directly to battery voltage (12V)
and check that the motor operates smoothly. Next, reverse the polarity
and check that the motor operates smoothly in the reverse direction.
If the operation is abnormal, replace the motor.
|
SS-B Solenoid Valve(ON/OFF) Removal
1.
Disconnect the negative (-) battery cable.
2.
Remove the air cleaner assembly and air duct.
(Refer to Engine Mechanical System - &qu ...
Valve Body Components Location
1. Pressure Controle Valve(PCV) adjust screw
2. Solenoid valve
3. Oil temperature sensor
4. Accumulator
5. Low & Reverse Brake(LR/B) pressure flow hole
6. Underdrive ...
AGM Battery Inspection
Battery Diagnostic Flow
Vehicle parasitic current inspection
1.
Turn all the electric devices OFF, and then turn the ignition
switch OFF.
...